In nearly all situations, most people spend quite a lot of money purchasing their forklift. Thus, it is extremely essential to take good care of it so as to protect your investment well into the long run. It is really a great idea to know the procedures that are carried out in the care and maintenance of this piece of machine.
One of the best ways to tell how good the engine is running is by starting the forklift up and listening carefully to see how it runs. For instance, if there are any misses or knocks, the machinery is defective and this should raise some concerns. Furthermore listen carefully for any squealing sounds that come from the belts as these noises would provide you with a wealth of information.
When carrying out maintenance, several of the main parts you will have to pay attention to comprise the safety warning devices, horn, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty parts have to be replaced as soon as they are noticed. It is also essential to check the wiring.
When the above parts have been checked thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every battery cell has to be inspected in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be regularly replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been completed and new filters have been fitted, visually inspect the drive axle from underneath the machine. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, inspect each and every other component of the machine including the wheels. If any kind of problem or fault is detected, be certain to deal with it immediately in order to make sure the machinery is working at its safest and optimum levels.